Tour tough built, sleek design, impressive specs, excellent cost per watt performance, efficient under any application. With these credentials, FBT proudly presents the new AX series of power amplifiers, the perfect power mates for sound reinforcement speaker systems. The AX series consists in four 2HU rack mount models, from 800 to 3000 watts, all designed with sophisticated power amp circuits for improved quality, stability and reliability, all equipped with Stereo-Parallel-Bridge operation mode, dB sensitivity switch (26-29-32dB), limiter, ground lift, XLR/Jack inputs (plus extra RCA input on AX 800), Speakon/Binding posts outputs.
SR 707 Power Amplifier
SR707 700 Watt Power Amplifier
POWER AMPS SPECIFICALLY DESIGNED FOR CONTRACTORS
The feature-packed SR series of power amplifiers is versatile, rugged and time-tested. The Asystems SR707 power amplifier is specifically designed with the needs of sound contractors in mind. Output is selectable between low-impedance, or 25V, 70V and 100V Line operation, dependent on wiring. Looking to expand your system? An XLR thru output is also available on each channel for line-level signals to additional amplifiers. Each amplifier channel has a separate toroidal secondary transformer that provides full electrical isolation and ensures maximum audio separation. Features like power up muting, full short-circuit, temperature, DC offset protection and a built-in 45 Hz subsonic filter help make the SR series an attractive, attractive solution for any audio installation.
Features:
|
|
Specifications:
| Direct Power Out | |
| 8 ohm | 240 Watts x 2 |
| 4 ohm | 400 Watts x 2 |
| 2 ohm, 1kHz, 1%THD | 550 Watts x 2 |
| Bridged mono 8 ohm, 1kHz, 1%THD | 800 Watts |
| Bridged mono 4 ohm, 1kHz, 1%THD | 1100 Watts |
| Isolated Constant Voltage Out | |
| 200V or 140V Bridge | 400 Watts |
| 100V or 70V | 350 Watts x 2 |
| 25V | 280 Watts |
| Frequency Response | |
| Direct Outputs (+0/-2dB) | 50Hz – 50kHz |
| Isolated Outputs (+0/-2dB) | 50Hz – 16kHz |
| Total Harmonic Distortion | <0.05 |
| Sensitivity (for full output) | 1.02V |
| Voltage Gain | 28dB |
| Input Impedance | |
| Balanced/Unbalanced | 20k/10k ohm |
| Damping Factor | >200 (direct output) |
| S/N Ratio | Less than 100dB below rated output (20Hz – 20kHz) |
| Protection Circuits | Output offset voitage protection |
| Heat sink overheat protection | |
| Transformer overheat protection | |
| Load shorting protection | |
| Power on/off protection | |
| Controls | |
| Front Panel | Power Switch |
| Rear Panel | Ch 1 & Ch 2 gain controls (41 click); Parallel/Stereo/Bridge Switch |
| Connectors | |
| Input | XLR Jack x 2, Barrier Strip x 1 |
| Output | Covered Barrier Strip x 2; Heavy-Duty Binding Post |
| Cooling | One dual speed fan |
| Indicators | Clip: Red |
| Signal: Green | |
| Protect: Yellow | |
| Power: Red | |
| Dimensions (HxWxD) | 132 x 480 x 428mm (5.2” x 19” x 16.9”) |
| Net Weight | 24.7 Kg (54.6 lbs) |
Click here to download Asystems SR 703 & SR 707 Power Amplifiers Brochure
Click here to download Asystems SR703 & SR707 Power Amplifier user manual